news

news

盘锦防水卷材

Panjin Yongcheng Waterproof Building Material Co., Ltd.

National Free Service Hotline: 400-0427-579

24-hour sales service hotline: 18642703399

Sales Director: 13998788788

Mailbox: 2006pjyc@163.com

Telephone: 86-427-5840444

Biography: 86-427-5844111

Website: www.pj-yc.com

Contact address: Panhai Road, Xinli Town, Dawa District, Panjin City, Liaoning Province


How to use waterproof coiled material to solve the problem of water seepage on the wall

Release date:2018-09-21 Author: Click:

How to use waterproofing membrane to solve wall bleeding and Panjin SBS modified asphalt waterproofing membrane water seepage is a problem that builders are very concerned about. Wall bleeding causes mildew and powder on the wall, and there are many reasons for wall water leakage. It is also very troublesome to remedy, the most important thing is to find out the cause, so that we can find a solution. The following waterproof membrane manufacturers summarize the following four situations for everyone.

1. If the concealed pipe of the upper water pipe is not installed properly, the water pipe is of poor quality, and the galvanized pipe is rusty and aging, it may cause water leakage. If the water leakage is caused by the rust and aging of the galvanized pipe, the galvanized pipe can only be installed at the leaking place, and the galvanized pipe is easy to be corroded, so it is best to replace all the galvanized pipes.

2. The waterproof layer of the light-body wall in the shower area does not reach 1.8 meters. The light-body wall is prone to damp in a humid environment all year round. For the health and safety of the home, it is recommended to knock off the wall tiles and re-waterproof it.

Panjin SBS modified bitumen waterproofing membrane

3. There are cracks in the outer wall, causing the asbestos in the wall to be wet all the year round. The asbestos in the wall is not easy to dry after absorbing rainwater, and over time, the inner wall will appear watery, mildew, and powder. If this happens, consumers should promptly notify the property for repairs and should not solve it by themselves to avoid accidents.

4. When the house was built, the construction hole of the outer wall was not sealed properly. Once it rains, rainwater splashing into the construction hole will cause the inner wall to regain moisture. After the wall dries, band or ring marks will appear. Since the construction holes are mostly located in the flue and exhaust holes, this situation often occurs on the walls near the flue and exhaust holes. If this happens, it should be reported to the property in time.


The URL of this article:http://en.pj-yc.com/news/392.html

Key words:

service
share it One-click sharing
Welcome to leave us a message
Please enter the message content here, we will contact you as soon as possible.
name
name
phone
phone
email
email
address
address