The waterproof membrane is made of polyester fiber non-woven fabric, jute cloth, glass fiber felt, etc. as the base, and the plastic film is used as the anti-adhesive isolation layer. After material selection, ingredients, eutectic, infiltration, composite molding, crimping, etc. Process manufacturing. This kind of waterproof membrane will have comparative advantages after being produced through this series of processing procedures. Panjin SBS modified bitumen waterproofing membrane

It can be waterproofed very well and has strong extensibility. It is widely used in many cold areas because the performance of this kind of waterproofing membrane is many times stronger than that of ordinary ones. The construction is relatively simple, but in Before construction, there are also points that manufacturers of waterproof membranes need to remind everyone to pay attention to.

Panjin SBS modified bitumen waterproofing membrane

First of all, clean up the surface to be decorated reasonably, and then apply the paint, paint it on the base layer of the waterproof treatment, and wait for it to dry before continuing to paint, but sometimes it will be restricted by the place of use. It cannot be installed. For example, in places where the drainage is accumulated and icy all the year round, and the base layer itself is uneven, it is not recommended to lay the waterproof membrane, and the laying effect will not be very good, which wastes materials. In the actual application of life, the construction structure of the area should be observed first.